Quote:
|
Originally Posted by cinnabar8521 You are wise beyond your years Grasshopper! Now if you want us to believe you were really a UG Chemist, then you will promptly pass along your recipe for Test base in oil. |
LOL that was a bitch to get to stay in solution even about 50mg's/mL.....I was able to get 100mg's/mL to stay in solution with 20%BB and 10%BA (this much BA will cause a little pain in some people).
However the "trick" was in the heating/baking of the juice while making it. The melting point of Base is very high, if I remember it was around 350 degrees farenheit. You had to heat the oil a little past the melting point of base for about 10 minutes then just turn the oven off and let the solution cool down on its own, takes awhile....
Keep in mind cooking the gear at that temp will cause some of the BB and BA to evaporate so you have to experiment with the evaporation rates to know how to end up with 20%BB, 10%BA.
There are other solvents that can be used but to get base to stay in solution at even higher concentrations but since I can't guarantee they are safe I won't post them.
Cronk.....The longer the ester chain the less solvent percentages you'll need due to all longer ester steroids being more oil soluble (those extra carbon atoms make the compound more soluble).
Also go with a little more BB then 7.5%....the BB is the primary solvent and is NOT water soluble. This means that after injection the BB stays at the injection site and keep the powder dissolved. BA being water soluble is absorbed quick by the musle tissue leaving the other compounds behind to sit in the muscle.
This is why if you don't use BB you will often get some serious pain from those lower ester chain compounds like
prop.