Men's Health Forum: This is a discussion on hcg question within the Anabolic Steroids forums, part of the extensive steroid information at MESO-Rx; i havd novarel 10,000 iu , is there any way to split it up so it dosent go bad , ...
i havd novarel 10,000 iu , is there any way to split it up so it dosent go bad , im only doing 250 iu per week with my test depo and at about 45 days i still have more then half ? please let me know its such a waste
i havd novarel 10,000 iu , is there any way to split it up so it dosent go bad , im only doing 250 iu per week with my test depo and at about 45 days i still have more then half ? please let me know its such a waste
It is so hard to do that... The powder is in the bottle... How do you supposed you're going to extract it and then split it??... Plus the stuff is very finiky... You almost need to walk on egg shells while dealing with HCG.... or else you're going to surly ruin it for good.
Thats a damn good question- one that I`ve been wondering about for some time. So far my best answer is to mix and store it carefully and use it up in 6-8 weeks. It comes out to about 1500iu/wk. Seems to be working for me.
The other option is to make a sterile field, divide and store the powder.
It is likely stored in nitrogen gas in the vial.
Nitrogen gas is available in a canister- many chemicals are required to store in an oxygen free environment.
Bacteriostatic water is available as are sterile vials.
Its just too much hassle.
Just use less T and more hcg/week.
Works for me.
GL
__________________
Better Living Thru Understanding Biochemistry
I spoke with an MD who has read serveral periodicals that freezing it does not lose more than 3-4% integrity. I have done it both ways and not noticed a difference. The only difference I have noticed is when I do it IM vs subc
You might try to mix it up with the small amount of water it usually comes with. They get the smallest insulin pins you an find. Preload them all and immediately transfer to a steril rubbermaid container. loading these small pins with MINIMAL water will deminish the amount of oxagenated water that it has to suffer though. Freeze them all. Any expansion will be dealt with by the plunger bakcing up, thus no extra air in syringe. Pull out 7 every friday night before the next week and put them in the fridge.
Note be careful. I have only hypothesized this and not had the chance to try it yet. Make sur those pins dont break off do to the freezing. I speculate they wont. However, I would press a few with finger or something, then sterilize needle of course, to try to see if they are weakened. Dont go it all the way with the pin until proven... This might hold them for a while.
You might try to mix it up with the small amount of water it usually comes with. They get the smallest insulin pins you an find. Preload them all and immediately transfer to a steril rubbermaid container. loading these small pins with MINIMAL water will deminish the amount of oxagenated water that it has to suffer though. Freeze them all. Any expansion will be dealt with by the plunger bakcing up, thus no extra air in syringe. Pull out 7 every friday night before the next week and put them in the fridge.
Note be careful. I have only hypothesized this and not had the chance to try it yet. Make sur those pins dont break off do to the freezing. I speculate they wont. However, I would press a few with finger or something, then sterilize needle of course, to try to see if they are weakened. Dont go it all the way with the pin until proven... This might hold them for a while.
Just change the pins and you'll not have to worry about them breaking of if frozen.
I have done this several times...no need tochange out the pins. I mixed 1:1 and had no problems. I pull out the freezer and 2 minutes later its ready to inject.