20 gauge needles

[ForceFed]

I just got a cycle of Sustanon 250 preloaded disposable syringes. Each one is 250 mg's. This will be my first cycle. The problem is they are each 20 gauge needles and I have never injected myself before. I am not at all afraid of needles but these fuckers look kinda fat to me. Should I be worried? Has anyone ever used 20 gauge before? Maybe I just need some motivation. Tell me to suck it up and not be a pussy.

[Bob Smith]

A 20ga is like trying to push a garden hose into your muscle! If you are able to chance the needles on them, stop at your local pharmacy and pick up some 23 or 25ga pins.

[eleven11]

Originally Posted by Bob Smith

A 20ga is like trying to push a garden hose into your muscle! If you are able to chance the needles on them, stop at your local pharmacy and pick up some 23 or 25ga pins.

Agree. Buy your self some 23 or 25g pins, remove the pin and shoot the redijet into it then screw the pin back on. this will also allow you to do ED or EOD shots...........11

[freedomfighter]

Just get a 5lb mallet out and pound that sucker in. Better yet listen to Bob and eleven11. OK I admit it, once I drew up a shot using a 20g needle to draw it up. I forgot to switch to my usual 23g and stuck it in. It hurt a bit and I wondered why the oil went in sooo easy. Doh, when I withdrew I was enlightened.

[flexter2005]

DOn't forget to lube up the new needle with the oil.. it makes a big difference.

[ForceFed]

thanks for the advice, i appreciate it. what should i tell the pharmacist i need the pins for?

[Massive690]

Originally Posted by freedomfighter

Just get a 5lb mallet out and pound that sucker in. Better yet listen to Bob and eleven11. OK I admit it, once I drew up a shot using a 20g needle to draw it up. I forgot to switch to my usual 23g and stuck it in. It hurt a bit and I wondered why the oil went in sooo easy. Doh, when I withdrew I was enlightened.

lol, i did the same thing except with an 18g drawing pin, it was kinda nice the way the oil went right in

[DakotaDave]

Originally Posted by ForceFed

thanks for the advice, i appreciate it. what should i tell the pharmacist i need the pins for?

I always told them I worked at a machine shop and used them to grease/lube the bal bearings in the machines. If you don't want to go to a pharmacy, just go to www.getpinz.com, they have em for good prices. Shipping is very cheap, and discrete. Don't use the pre load pins. I used them on my first cycle and it felt like I got fu#*ed in the but cheek. Good luck with your cycle.