Crystals floating in his test - MESO-Rx

1baddeuce · #1 (**permalink**) 07-07-2009, 06:20 PM

My friend noticed there are alot of crystals floating in his test e. He is in his 6th week and the injects are smooth and painless even with the crystals. Is this going to be a problem if he keeps pinning with crystals in there or will they dissolve in the muscle ok?

Mr Wiggly · #2 (**permalink**) 07-07-2009, 07:30 PM

Sounds sketchy, mabey warm it up in some really hot water and see if it melts. If it doesnt hurt then mabey its fine but I would be concerned about anything that wasnt suspended properly. See what other guys say.

MrBman · #3 (**permalink**) 07-07-2009, 07:51 PM

ive had this problem before ... let my gear sit for about 10months and checked on it again - it had crystals in it ... bench told me to do this and it worked quite well ... boil water - keep it below 100 degree Cel. .... take a syringe, unscrew the pin off and stick that into the rubber top of ur bottle ... this'll enable air to vent out as it the air will obviously expand when the bottle is heated ... take tongs and dip ur gear bottle into the water ... shake the bottle every now and then - every 5mins take the gear outve the water, and shake ur bottle and check on it - crystals should dissolve within 10mins ....

lastchance · #4 (**permalink**) 07-07-2009, 08:28 PM

Quote:

Originally Posted by MrBman

ive had this problem before ... let my gear sit for about 10months and checked on it again - it had crystals in it ... bench told me to do this and it worked quite well ... boil water - keep it below 100 degree Cel. .... take a syringe, unscrew the pin off and stick that into the rubber top of ur bottle ... this'll enable air to vent out as it the air will obviously expand when the bottle is heated ... take tongs and dip ur gear bottle into the water ... shake the bottle every now and then - every 5mins take the gear outve the water, and shake ur bottle and check on it - crystals should dissolve within 10mins ....

x2

xsosinglesogoodx · #5 (**permalink**) 07-07-2009, 09:44 PM

get a pin and stick in vial release air and take out, do this every time after you take vial out of oven.

set oven to 325degress

put vial in oven for 6 min on a cooking pan like a cookie tray
take out swirl gently leave out for 3 min.
back in 4 min
take out swirrl gently leave out for 3 min.
back in 4 min
take out swirl gently leave out for 3 min.
this should do it don't over heat it, should take only 3 times maybe 4. should come back clear. good luck

peanutbutter · #6 (**permalink**) 07-08-2009, 03:51 AM

dont use it,you will get big pain when you shot..maybe even abscess.

Mr Wiggly · #7 (**permalink**) 07-08-2009, 09:16 AM

Quote:

Originally Posted by peanutbutter

dont use it,you will get big pain when you shot..maybe even abscess.

Ouch! Is that a glute? Mabey go for the ventral next time huh?

TZTARZAN2000 · #8 (**permalink**) 07-08-2009, 01:34 PM

i have a friend that makes prop for me with less BA then normal to ease the pain. i get crystals too. i just put my oven at 200 degrees and in 5 minutes they disolve. the only prob with putting in water with a pin in it is depending on how much is in your bottle or the amount of water is it will fall over in the pot.