Damn suspension jamming

[TheBigE]

I by no means new to AAS, but I've also never done this shit before. Using Anabolic TS and even tried using an 18 guage railroad spike! This sucks! I have noticed that keeping the needle pointing straight upward helps ( possible preventing large crystals from collecting at the begining of the needle) but you can only imagine the acrobatics involved with this maneuver! Even after removing the needle I have to push damn hard to clear the obstruction.

Any of you guys have experience with this brand of suspension? Any tricks that may help?

e

"I believe a man does what he can... until his destiny is fully revealed"

[Bob Smith]

I have no idea what you are asking.

Ill give an answer anyway to what I think you may be asking. Heat the suspension up in some hot water before injecting. That will make it less viscous. You should easily be able to shoot suspension through a 25 gauge needle.

[spound]

Originally Posted by Bob Smith

I have no idea what you are asking.

Ill give an answer anyway to what I think you may be asking. Heat the suspension up in some hot water before injecting. That will make it less viscous. You should easily be able to shoot suspension through a 25 gauge needle.

Yea, I can shoot mine through a slin pin! But I make my own

[TheBigE]

The question was:"What should I do to prevent the needle from jamming?" Sorry if I didn't make that clear. I wrote it in a hurry late last night after a frustrating injection failure... But thanks for the advice and I guess I'll try heating it up prior to injection. Would you recommend preheating the entire vial or just the loaded syringe?

[Bob Smith]

Either way, but its normally easier to heat the entire vial. I cant figure out why you cant push suspension through the garden hose you were using. As spound said, you should be able to get it through something even as small as a slin pin.

[Bob Smith]

A cup of water in the microwave for about 15-30 seconds works very well.

[TheBigE]

Tried heating it up. Made absolutely no difference. This shit jams the needle even while withdrawing it from the vile. There has got to be at least a 1/2 inch of white powder or crystals that settles out in the bottom of the vile when left to sit a while. I tried 4 different times tonight, and was pushing on the plunger so hard at one point that my cheap non-locking syringe actually separated from the pin and exploded suspension into my face. Maybe I just got a bum mixture. The particulate size is just too damn big to clear warmed up or not. I'm pissed...

[Bob Smith]

Id ask for a refund.

[morepain]

anabolic ts is notorious for this, its not micronized the particle size is ridiculous and as stated it settles out very easily and will clog nearly any pin