diluting juice to ease pain

[*Bj*]

my sus, eq cycle is going good but its a little painful. I shoot every other day so now my delts, right quad, left glute, and right tricep are all burning and a little swolen. The pain is tolerable but there are a lot of restrictions like sitting, lifting and even sleeping are very uncomfortable. Can I simply add a cc of canola oil to my shots or any other way of reducing the pain and swelling? I've tried massaging, heat pad, ice, but none of that shit helps. Please help I have to poke myself in about 8 hours.....Bj

[Bob Smith]

You could try canola oil, but Im not sure how sterile it would be.

[j martini]

Is it the sus are EQ that causes the pain. If it is the sus mix some EQ with it.

[toc67guru]

are you using UG equipoise?

if so what isits dosage mg/ml?

[lowtone]

For now 800mgs Advil will make you feel 100% better! Go to gearbox and have them send you some oil to cut your shit with. Until it gets here, mix the two in the pin and warm under running water before you shoot it.

-LT

[Bob Smith]

Originally Posted by j martini

Is it the sus are EQ that causes the pain. If it is the sus mix some EQ with it.

EQ should be painless.

[j martini]

Originally Posted by Bob Smith

EQ should be painless.

Yeah, what i was saying is that if it was the sus causing the pain increase the volume of injection by adding some of the EQ to his shot of sus.

[*Bj*]

I was doing 1cc RS Sus 250 and 1cc RS EQ 200 eod for the first 2 weeks then lowered the eq to 1/2 cc(I figured 800mg eq per week is a little much) with the same discomfort level. RS gear is usually painless for me but there is redness and swelling all over. I'm actually running out of places to poke. Bj

[toc67guru]

i was just concerned with the equipoise as some UG labs are putting it out in 400mg/ml and may have been high in alcohol causing the discomfort.
what you could do is get some sterile oil and add say 1-2ml to the shot to increase the volume and dilute it for less pain.i know this works for T400.
it may just be the prop ester in the sus that is the problem.

[greyowl]

Originally Posted by toc67guru

i was just concerned with the equipoise as some UG labs are putting it out in 400mg/ml and may have been high in alcohol causing the discomfort.
what you could do is get some sterile oil and add say 1-2ml to the shot to increase the volume and dilute it for less pain.i know this works for T400.
it may just be the prop ester in the sus that is the problem.

Sus is just damned painful no matter how you cut it. EQ should be painless.

Do you heat the syringe before injecting ... that might help.

[*Bj*]

I've never tried to heat the pin before injection, i'll try it right now(if I can find a place to poke). How does heating the pin help anyway, what does it do to the juice? Bj

[Bob Smith]

Originally Posted by *Bj*

I've never tried to heat the pin before injection, i'll try it right now(if I can find a place to poke). How does heating the pin help anyway, what does it do to the juice? Bj

It makes it flow easier.

[greyowl]

Originally Posted by Bob Smith

It makes it flow easier.

Also, if you think the pain comes from BA you can bake some of it our of the test.

[*Bj*]

how do you bake the BA out of test?

[jboldman]

best to just dilute with canola oil. filter it first.

jb