Steroid Forum: This is a discussion on How do i make injectable Test Suspension from base? within the Anabolic Steroids forums, part of the extensive steroid information at MESO-Rx; anyone ever made injectable test from:
test base powder
oil
BA
BB
filter, vials, etc are obvious. i was just ...
How do i make injectable Test Suspension from base?
anyone ever made injectable test from:
test base powder
oil
BA
BB
filter, vials, etc are obvious. i was just wondering if another solvent would be needed. i heard someone say you can make it at 75mg/mL using oil, 5% BA, 10$ BB????
Ive heard some bros have success with making a painless suspension with PEG-200... perhaps musclechemistry.com would have some more info for you.
Otherwise I can send you a little of my TDS delivery system and you can use your own test powder... infact thats the same powder I use. Did you get it from good old Chu? Good stuff... tested out at 97% purity. -ES
i did mine with grapeseed oil, 5%ba and 15%bb......but it does crash from time to time...but i did it at 100mg/ml...but it is totally painless...test base is a bitch to work with, winny is the worse, but still its worth it in the end...its my fav. form of test...you could also use a super solv. to convert it,,,,i know some bros that have had good success with that.......LP
i did mine with grapeseed oil, 5%ba and 15%bb......but it does crash from time to time...but i did it at 100mg/ml...but it is totally painless...test base is a bitch to work with, winny is the worse, but still its worth it in the end...its my fav. form of test...you could also use a super solv. to convert it,,,,i know some bros that have had good success with that.......LP
ppp
Last edited by borrachopower; 09-02-2004 at 12:23 AM.
As far as super solvents go, Dazed is supposed to have a good one. www.eagleresearch.biz It's made, I think with BA, BB, and PG and PPG, which is what makes it able to dissolve so much more with so little pain. Propylene Glycol and Polypropylene Glycol, I think? Pricing is comparable to Sesame Oil and the like in small amounts. $20 for 100mL.
Suspension is the shit, no doubt about it. Two or three cycles of it and you'll be hooked; no desire to use any other test. I don't understand why it's not more popular.
What's wrong with using basskiller's instructions for prop?
Give it a shot. I've seen the same general recipe on other sites, suggesting that it will work for prop and base. If it works, please let me know; I'll try it myself.
What I haven't seen is too many standard recipes using these magic solvents floating around. If you can use something less than the 10ml of BA/BA per 50 ml total, might make for a smoother stick of course.
How do i make injectable Test Suspension from base? 
Linear Mode
