Steroid Forum: This is a discussion on How to prevent injection pain within the Anabolic Steroids forums, part of the extensive steroid information at MESO-Rx; Or, you can put a drawing needle in the top of the rubber not touching any of the gear, use ...
Or, you can put a drawing needle in the top of the rubber not touching any of the gear, use a pan with water and some heat, and you can boil off the excess BA to lower the concintration.
Or, you can put a drawing needle in the top of the rubber not touching any of the gear, use a pan with water and some heat, and you can boil off the excess BA to lower the concintration.
If you are going to do the oil route then use EO.
Thats a novel idea hacskii ,I didn't think of that one
__________________
If you want to be Huge,you must learn to Suffer
This stuff hurts! I have Supertest 450mg/ml and I'm wondering if I should cut it and at what ratio. Also would letting some of the BA evaporate using a pin while baking in oven help?
I think you would be better off with a pan filled with a little water on the stove, the BA boils off fairly easy and will make like frosting on the drawing needle as it is boiling off.
Just be careful how far down the needle goes, if it touches the gear it will push it out of that bottle and into the pan.
Generally though cutting gear with EO oil works very well.
Only bummer is drawing the EO oil, it locks up the syrenge when you try to use it.
Its like it attacks the rubber or something.
Do you think keeping gear in the syringe is safe (more sterile, less contamination) or should I transfer to vial? The Supertest 450 I need to cut comes in sachets not vials and I need to keep it somewhere.
They have multiuse vials at research shops, I cant see why you could not toss some EO in there and put all that through a filter into a sterile multiuse vial.
Only diffrnece will be less pain but also less mg per ml.
EO is the way to go, killer stuff for thining the gear out and cutting the pain.
They have multiuse vials at research shops, I cant see why you could not toss some EO in there and put all that through a filter into a sterile multiuse vial.
Only diffrnece will be less pain but also less mg per ml.
EO is the way to go, killer stuff for thining the gear out and cutting the pain.
What are the benefits to using EO over inexpensive USP oil?
Re: How to prevent injection pain 
Linear Mode
