PL winstrol problem

[j-hawk]

Hey guys I just got a couple of bottles of his Winstrol. I am having a hard time drawing into the syringe, any suggestions?? I hope it is alright. Thanks

[chiseled21]

I too am having troubles with the winny, it is 60 mg and will not draw into a 23 gauge. I considered drawing with a 18 but what difference does it make; if you cannot draw with a 23 you will not be able to shoot with it once it is in the barrel. I would like to avoid shooting with an 18 at all cost(18 gauge shots every day would not be fun) any suggestions would be appreciated.

[chiseled21]

bump....please offer any valid advice

[Darryl]

I wasnt able to inject with 25 guage so I had to drop to a 22 for it to go through..thick stuff

[cracka]

You may have to shoot with a 21g ... it's better to go too big then too small and get a clog while injecting a winny like you're using. Unfortunately you don't have a lot of options ... that's why I think zambons are worth the extra cheese.

If 21g pins sting a bit much ... try putting them in the freezer (the pins, not the winny).

[bigkb]

When I used test suspension (RWR) once, it did the same thing. I was able to draw it into a 22, but it would jam up every single time when injecting. So what I did was.. and alot of people know about this.. was just draw it, then run the syringe under hot water for a couple of minutes, then shake the syringe hard, then immediately inject. Worked well every time, never jammed up again. I did this with Winstrol (also RWR) too, and it worked well.

Whether this will work with a 23 or 25 though, I don't know. I have also wondered if heating it destroys some of the drug.. not sure.

You know, you can also just drink Winstrol (and liquid Dbol). It is just as effective orally, because it is alkylated just like orals. I have heard that you need to use a slightly higher dose though if it's taken orally. I'm not sure I can believe that, but many have said it.

Hey another thing that seemed to help was drawing in a tiny bit of an oil injectable, to lubricate the inside of the needle.

KB

[chiseled21]

Thanks for the advice

[CORV]

Originally Posted by chiseled21

Thanks for the advice

I've had nothing but problems with PL water winny. Two bottles turned green inside and 1 more turned into some kind of unmixable mush!!! Never Again!!

[motoman]

Originally Posted by j-hawk

Hey guys I just got a couple of bottles of his Winstrol. I am having a hard time drawing into the syringe, any suggestions?? I hope it is alright. Thanks

DPHARM. 100MG/ML 23g no problems
the best out

[Cronk]

Originally Posted by CORV

I've had nothing but problems with PL water winny. Two bottles turned green inside and 1 more turned into some kind of unmixable mush!!! Never Again!!

I have the man's H2O winny and it passes through a 23G no problem. No discoloration either. Both bottles are even slightly overfilled. Just my 2 cents.

Cronk