Question Bill Roberts?baking 250 f is bad for tren...Can it be heated at lower temp ? - MESO-Rx

rickfrost · #1 (**permalink**) 05-02-2009, 09:11 PM

Question Bill Roberts? baking 250 f is bad for tren...Can it be heated at lower temp for instance 160-175 in oven? made a 40 ml batch at 250 degrees, looks ok but does :hormone lose potency...I am currently off cycle

The follwing is from another board or previous post

The following is what you need to make your own tren at home without a kit! IT works 100% bro's!

Two old large vials.... one with the top off and one with the rubber top still on.......30cc or bigger or buy off the net.
Buy some BA(Benzyl Alcohol) over the "net"
Buy syringe filters off the net or use an old one that has been cleaned with acetone and dryed
Wesson soybean oil from any store.
Candy thermometer of $3
2000mg of Finaplix H off the "net"

RECIPE

Dump 2000 mg of Fina pellets in the vial without the top. Pour in 5 cc of BA. You can then crush it up and heat it very slightly and stir or simply let it sit over night in order to get the pellets to dissolve. Make sure all of the pellets are dissolved. You now have about 7 cc of solution....5cc of BA and a couple for the fina.

Next add 10 cc of soybean oil and shake it up. Let it settle for a few hours and then filter with a .2 micron filter into a vial with a rubber top intact(old vial will do). Don't try to suck up the sediment

Next put 10cc more oil into the vial with the sediment and shake again , let settle and filter once more into the other vial. This step gets all the remaining tren out of the sediment...we don't want to waste any tren.

STERILIZING
The .2 micron filter and BA is good enough BUT to be extra safe you may wish to pasturize.

NEVER EVER bake the tren in the oven at 250 degree's F as this will damage some of the hormone. (I learned this from Bill Roberts and a friend that I work with ....a pathologist in a lab)

Heat some water in a pan to 160 dgree's F and keep the heat constant. The best thing to use is an electric frying pan. Always check the temp with a candy thermometer.
Put the finished product into the water and leave the rubber top of the vial uncovered. Pasturize for 35 minutes at 160-170- degree's. Remember to take some air out of the vial to allow air expansion.

There you have it bro's a 75 mg per ml home made tren mix.........HINT The "magic solution" is simply Benzyl Alcohol bro's....it's not rocket science.