Test Reaction? - MESO-Rx

jaybird0825 · #1 (**permalink**) 02-08-2004, 01:19 AM

Any chance of Testoprim-D (prop and enan) causing or enhancing cold-like symptoms? Both times I've shot it, i've gotten REALLY bad cold symptoms and don't know if it could be the test doing something in my system or if it's just really bad timing. Not really helping my drive to get to the gym, that's for sure.

LuvMuhRoids · #2 (**permalink**) 02-08-2004, 04:09 AM

It's your system adjusting to the introduction of test. Your hormones are off balance. You're system has it's own natural ability to keep a natural balance and it is being shocked and has to get used to the new introduction of artificialy increased hormones. If im wrong I would up your muti-V and drink gallon or more of distilled water daily. If it persists later into the cycle then seek medical and stop the injections. LMR

jaybird0825 · #3 (**permalink**) 02-10-2004, 05:22 PM

Getting better already. One other thing I've noticed that I don't remember from teh first cycle I did... Every time I hit my glute, I get a huge knot about two days later that hurts like hell. If you cut an egg, length-wise and stuck it right inside the muscle, that's about what it feels like. Is this something I'm screwing up? I don't dig the pin around or anything, but I can't figure out why I'm getting this lump and why it's taking so long to form. If it was just product, wouldn't it show up immediately after the injection?

Snowblind · #4 (**permalink**) 02-10-2004, 05:35 PM

What length of needle are you using? And how fast are you injecting? The prop in there could have something to do with it.

jaybird0825 · #5 (**permalink**) 02-10-2004, 05:41 PM

1 1/2" needle. What would the prop be causing?

jaybird0825 · #6 (**permalink**) 02-10-2004, 05:43 PM

and I inject it rather slowly. It seems like it takes forever. It always feels like there's a bit more resistance than I would expect, but I think that's just the stiffness of the plunger in the res.

Snowblind · #7 (**permalink**) 02-10-2004, 05:52 PM

Quote:

Originally Posted by jaybird0825

1 1/2" needle. What would the prop be causing?

I typically have the same thing you describe while using prop, but by itself. If I cut it with something, it's usually fine. You have a blend, so not sure what the problem is. Sounds like you're doing everything else right.

Bump for more responses.

jaybird0825 · #8 (**permalink**) 02-11-2004, 12:13 AM

OK, this is where I broadcast what newbie I am... What does it mean to "Bump for more responses?"

chris gordon · #9 (**permalink**) 02-11-2004, 10:15 AM

it means ...keep this near the top of the page so more peiople will see it and have a chance to respond

jaybird0825 · #10 (**permalink**) 02-13-2004, 01:27 AM

thanks